If you buy after clicking affiliate links on this site we might receive a commission from companies such as eBay, Amazon etc This does not affect the price you pay.
If you buy after clicking affiliate links on this site we might receive a commission from companies such as eBay, Amazon etc This does not affect the price you pay.
If you buy after clicking affiliate links on this site we might receive a commission from companies such as eBay, Amazon etc This does not affect the price you pay.
Click here to see similar items, and to buy from eBay.
Up for grabs is a used Crown / C-Audio Pulse4 x 300 Watt lightweight Power Amplifier. Its is 300w per channel (all 4channels) or 2 x 660w 4ohm bridged mode.
British designed and built.
This is an 11kg lightweight switch mode 4 Channel amplifier capable of runningmany configurations depending on the impedance of your speakers.
This one has Speakon connections on the rear NOT binding posts.
The amplifier is in full working order and sonically sound, everything workingas it should. It was fully serviced & fully updated to current Crown / C-Audio specin 2016 (mods to power supply etc). Since then it has had light usage in mymonitor rack.
At the flick of a switch you can bridge channels 1+2 and 3+4 independentlycreating a two channel amplifier and delivering 660w into 4ohms per channel, Ihave sometimes run this amp with channel 1+2 running my tops and 3+4 bridgedinto a sub bass bin.
Cosmetically I’d say it was 7/10, the fans are clean & there are minor scratches / marks to the bottom &top casing (as you would expect) from life on the road.
This amp has been truly wonderful for me, never had any issues, superlightweight and super flexible for different scenarios. Will be fully checked & tested before dispatch & comes with a IEC power lead.Specs:Power Ratings Pulse 4×300
Measured per channel, both channels driven at 1kHz to no more than 0.1% THD+N
8 Ohms 170Wrms
4 Ohms300Wrms
2 Ohms 330Wrms*
* Note: 2 Ohm spec is at 1% THD
Bridged Mono
16 Ohms 400Wrms
8 Ohms 600Wrms
4 Ohms 660Wrms*
* Note: 4 Ohm bridged spec is at 1% THDInput Sensitivity +1dBu for full outputInput Impedance 20kOhmDistortion <0.006% THD, 1kHz, 1dB below clip, 22kHzmeasurement bandwidthFrequency Resp. 20Hz to 20kHz, +0/-0.2dB; <2Hz to >120kHz+0/-3dBControls Power switch, bridge mode switching, indented levelcontrols (these may be made tamper-proof)Indicators Mains present, Operate, Signal, Bridge, Clip,Over temperature, Protect, RemoteProtection Microprocessor supervised: over temperature, DC onoutputs, output stage overload, inrush current surge, mains fail and brownout.Noise < -100dB ref full output 20Hz - 20kHz measurement bandwidthSlew Rate >50 V/microsecondDamping Factor >200 ref 8 OhmOutput Connectors 4×300 – SpeakonPower 115 or 230 volts AC nominal, internally selectable, 2000VA, all channelsdriven.Dimensions 3.5″ (89mm) x 18.2″ (460mm) x 19″(483mm) – with rear rack ears depth 19.5, -21, 20 (494, 511, 530mm)Weight 24lbs(11kg)
NO NEW USERS OR OVERSEA BIDDERS, UK ONLY.
If you buy after clicking affiliate links on this site we might receive a commission from companies such as eBay, Amazon etc This does not affect the price you pay.
Click here to see similar items, and to buy from eBay.