If you buy after clicking affiliate links on this site we might receive a commission from companies such as eBay, Amazon etc This does not affect the price you pay.
If you buy after clicking affiliate links on this site we might receive a commission from companies such as eBay, Amazon etc This does not affect the price you pay.
If you buy after clicking affiliate links on this site we might receive a commission from companies such as eBay, Amazon etc This does not affect the price you pay.
Click here to see similar items, and to buy from eBay.
BOUGHT FOR AN INSTALLATION BUT NOW NOT NEEDED
Power SourceAC: 230 V
DC: 24 V/15 A
Applicable cable diameter: AWG22 – AWG14Power Consumption on AC MainsWith no signal present: 54 W
Under normal operating conditions according to
EN60065: 1998 sec. 4.2: 255 W
With rated output signal: 549 WCurrent Consumption on 24 V DC Power InputWith no signal present: 1 A
Under normal operating conditions according to
EN60065: 1998 sec. 4.2: 5 A
With rated output signal: 14 ARated Output240 WOutput Voltage /Impedance100 V/42
(selectable by the internal wiring change)Frequency Response50 Hz – 16 kHzDistortion1 % or lessSignal-to-Noise Ratio60 dB or moreTone ControlBass: 100 Hz 10 dB
(Inputs 1 – 3 and BGM individually adjustable.)Remote Microphone /Expansion Amplifier Connection2 RJ45 female connectors for connecting the RM-200M Remote
Microphone and the VM-2120 or VM-2240 unit used as an
expansion amplifier.
Maximum distance: 800 m (874.89 yd) in total
Link cable: Category 5 Shielded
Number of connectable RM-200M’s: Up to 4
Twisted-Pair straight cable (TIA/EIA-568A standard)InputInputs 1 – 3: -60 dB(*3) (MIC)/-10 dB(*3) (LINE) (changeable)
600
combined XLR connector (female)/phone jack
(Only Input 1 is additionally equipped with DIN
connector(*5).)
Telephone paging input: Push-in terminal block(*6)
Voice sound: -10 dB(*3)
balanced input with shield terminal(*4)
Control: No-voltage make contact input
open voltage: 3.3 V DC
short-circuit current: under 1 mA
BGM 1 – 2: -20 dB(*3)
Power amplifier input: 0 dB(*3)
External speaker line input: 100 V line
(This input is selected when the “Unit’s
broadcast cutoff” control is activated.)OutputSpeaker output: Plug-in screw connector(*7)
5-zone selector with attenuator (all zones simultaneously
selectable)
Direct speaker line output: Direct output from the power amplifier
output transformer (attenuator bypassed)
Plug-in screw connector(*7)
Line output: 0 dB(*3)
Recording output: 0 dB(*3)
Preamplifier output: 0 dB(*3)Control InputFor controlling Inputs 1 – 3
No-voltage make contact input
short-circuit current: 1 mA or lessControl Input and OutputD-sub connector (25-pin
Input: No-voltage make contact input
short-circuit current: 1 mA or less
Output: Open collector output
control current: 10 mA or less
(1) External control input
Activation of messages(*8)
Activation of power
Activation and stop of Emergency Broadcast
Unit’s broadcast cutoff
(when activated by an external emergency equipment)
(2) Status output
Irregularity of communications with the Remote Microphone and
an expansion amplifier
AC power condition
DC power condition
Irregularity of the sound source of the Voice Announcement Board
Failure (FAULT) indication on
Power switch onExternal Attenuator Control OutputPlug-in screw connector(*7)
transfer type
contact current: 7 A (DC) or lessSurveillance Input and Output(*9)D-sub connector (25-pin
Input: No-voltage make contact input
Output: Open collector outputPower Supply24 V DC/0.1 A
Unit RU-2001/-2002Chime ToneBuilt-in chime: 2-tone chime/2-tone chime (fast repeat)/4-tone
chime (Up)/Single-tone chime/4-tone chime (Up &
Down)/Gong/off
Voice Announcement Board sound source: Pre-recorded chime(*8)FunctionTwo units stacking (VM-2120 or VM-2240)
Emergency broadcast (sequential control)
Broadcast priority control
Surveillance (failure detection) function(*9)
Power supply to only one Remote Microphone (RM-200M)
Line resistance: 40 (one way) or lessOperating Temperature0 to +40 (32 %%dF to 104 %%dF)FinishPanel: ABS resin
Case: Steel plateDimensions419 (W) 143.3 (H) 355.7 (D) mm (16.5 5.64″ 14)Weight14.5 kg (31.97 lb)AccessoryPower cable (2 m (6.56 ft)) 1
Miniature type time-lag fuse T3.15 A 1OptionRack mounting bracket: MB-36
Input transformer: IT-450
Voice announcement board: EV-200M
Surveillance board: SV-200MA
THANKS FOR LOOKING AND PLEASE CHECK OUT MY OTHER ITEMS
If you buy after clicking affiliate links on this site we might receive a commission from companies such as eBay, Amazon etc This does not affect the price you pay.
Click here to see similar items, and to buy from eBay.